Type A Midget Submarine

1
February 5, 2022
Decals are on, one of the stripes end up a little out of alignment, but I didn't catch until after it had set. Should be wrapping it up shortly.
2
January 28, 2022
3
January 28, 2022
4
January 28, 2022
5
January 28, 2022
6
January 31, 2022
Little bit of a gap around the tower here... not sure extra thin will fill it in.
7
February 2, 2022
8
February 2, 2022
Tamiya basic putty on the forward portion of the tower.
9
February 2, 2022
Used some plastic putty to fill the gap around the base of the tower.
10
February 2, 2022
Getting somewhere with assembly... I see much sanding and a bit of putty in my near future.
11
February 5, 2022
Almost done with assembly. Still have to do the net cutter, and the rods for the control surfaces. After that its priming painting and decals.
12
February 5, 2022
13
February 5, 2022
14
February 5, 2022
15
February 5, 2022
16
February 5, 2022
17
February 5, 2022
18
February 5, 2022
19
February 5, 2022
20
February 5, 2022
Drop damage
21
February 5, 2022
Drop damage
22
February 5, 2022
Drop damage

7 28 January 2022, 23:41

Cuajete
Following.

29 January 2022, 19:46

Robert Podkoński
Watching! Some time ago I finished the other incarnation of this kit:
Big one and small one | Album by podkon (1:72)
and I liked it very much 😉
If I may suggest you something - for such gaps like around the tower I use washable acrylic putty:
Washable Acrylic Putty (Wamod OD23, No)

1 February 2022, 07:03

Thomas Espe
Following!

1 February 2022, 16:32

James Barrett
Thanks! I have some plastic putty, I was going to give that a try.

1 February 2022, 16:53

James Barrett
Looks like the plastic putty is gonna do the trick.

2 February 2022, 01:49

Robert Podkoński
Good to hear this 😉

2 February 2022, 07:38

James Barrett
Got the net cutter, and the control surface rods into place. Everything should be ready for a quick tidy up. Then tomorrow priming and paint. If I can get it done early, I might have decals on it by the end of the day.

5 February 2022, 02:44

Ben M
An interesting subject!

5 February 2022, 04:12

James Barrett
Primed and painted. Now its time to clear coat, decal, and clear coat again.

5 February 2022, 19:22

Cuajete
Well done so far.

5 February 2022, 21:09

James Barrett
And I just dropped on the concrete while I was carrying out to the garage.

Oh well, win some lose some. I am still counting it as completed. Gonna put aside, might able to use the mangled remains for a diorama or something later.

5 February 2022, 22:53

Robert Podkoński
Sorry to hear and see that... still, it looks good, James!

6 February 2022, 10:29

Project info

Type A Midget Submarine

22 图片

1:72

已完成

1:72 Type A Midget Submarine (Fine Molds FS2)

所有相册

查看所有相册 »

Type A Midget Submarine

评论

Project info

所有相册