AMG GT3 #46 LiquiMoly 12hr of Bathurst '20 (Job Log)

Body parts. 

Assemble. 

Using 'Green Putty' and cyanoacrylate. 

White surfacer. 

The side mirrors can now also be gripped with tongs. Viva Tamiya~ ^_^ 

Detail-Up 

Ready for paint black surfacer. 

Done. 

And than, masking... 

The carbon pattern was painted using stockings. 

Close-up. 

Gloss black surfacer. 

I used 'Vallejo Mecha Primer' for this chrome plating part. 

Remove masking tape. 

ಠ_ಠ 

Recovered. 

Too rough pattern. 

Apply 'Hasegawa Finish (Carbon)' 

Start decaling. 

The face was easier than I thought. 

It was quite difficult here. 

The adhesion of the offset decal was not good.
So I cut off the white area. 

Black decal on the black?
I don't care. pass. 

The most difficult part of 'decaling'. 

Done 

Done. 

Maybe last masking. 

Easy seat belt tune-up. 

Gloss clear coat and brush painting. 

I used 'Tamiya Panel Line Accent'. 

I used 'GSI Super Smooth Clear(Flat)'
It becomes a very luxurious matte finish. 

Ready for assemble. 

Start assemble. 

I used sticker from the 'Bandai Pocket Mon' kit. 

Assemble Cockpit. 

Combine. 

Pre-assembly of parts requiring rigidity 

Assemble continue. 

Assemble continue. 

Assemble continue. 

Pre-assemble for rear wing. 

Metal sticker for mirror is best quality. 

Tire decal is too glossy. 

So I lowered the gloss. 

Now than, attached every small parts. 

Finally, attach the canard. 

Finish. 

Finish.