SA-8 Gecko/9k33 OSA
评论
2 22 November 2017, 07:14
Bart Goesaert
thx. hope not to disappoint. already looking out for some camouflage on this one, and maybe a small change to make it an AMK instead of a standard one...
thx. hope not to disappoint. already looking out for some camouflage on this one, and maybe a small change to make it an AMK instead of a standard one...
23 November 2017, 11:21
Bart Goesaert
Progress was a bit slower then expected... Wheels fitted under the hull, only 1 needs a bit of correction for not touching the ground (to me it's a succes...)
Also thinned down one support for the launchers... some tedious work, but luckily the resin isn't that brittle. Further I ran into a serious problem with the windshield part. It is approx. 1.5mm smaller then the hull, and I'm very puzzled how to deal with that
Progress was a bit slower then expected... Wheels fitted under the hull, only 1 needs a bit of correction for not touching the ground (to me it's a succes...)
Also thinned down one support for the launchers... some tedious work, but luckily the resin isn't that brittle. Further I ran into a serious problem with the windshield part. It is approx. 1.5mm smaller then the hull, and I'm very puzzled how to deal with that
5 October 2018, 11:25
Thomas K.
i have a tipp for the windshield: you can make self; you need only a plastic from a blister. so you can scratch the pice 😉
i have a tipp for the windshield: you can make self; you need only a plastic from a blister. so you can scratch the pice 😉
5 October 2018, 13:25
Bart Goesaert
thx Thomas, tried it first with the saw, whenall else fails, I can still try to scratch it completely...
thx Thomas, tried it first with the saw, whenall else fails, I can still try to scratch it completely...
6 October 2018, 19:49