F-16C big set
For Tamiya
Black Dog | 货号： A48081 | 1:48
基本信息
- 品牌:
- Black Dog
- 标题:
- F-16C big set For Tamiya
- 数量:
- A48081
- 比例:
- 1:48
- 类型:
- 细节改造件
- 主题:
- General Dynamics F-16 Fighting Falcon » 喷气机 (飞机)
设计为
该改件适用于：:
![1:48 F-16CJ [Block 50] Fighting Falcon (Tamiya 61098)](/products/img/6/4/1/102641-145538-15-t180.jpg){kind=small}
新模具![1:48 F-16C [Block 25/32] Fighting Falcon (Tamiya 61101)](/products/img/9/0/5/105905-15655-78-t180.jpg){kind=small}
新零件![1:48 F-16 C [Block 32/52] "Thunderbirds" (Tamiya 61102)](/products/img/3/4/5/122345-10000-t180.jpg){kind=small}
新贴花
新零件![1:48 F-16C [Block 32/52] "Thunderbirds" (Tamiya 89799)](/products/img/1/1/3/155113-11906-t180.jpg){kind=small}
新贴花市场
No partner shops available
开盒测评
外部链接评测
我们并没有任何关于此套件的开盒测评 F-16C big set (#A48081) 从 Black Dog.
评论
hamptonracingJust received my Big Set from Lucky Model. Typical Black Dog where it’s thrown into a bag and then inserted into a paint shaker just ot make sure that some pieces break off. One additional problem is that there are about 50 pieces in this set but zero instructions. I can probably sit down and figure everything out, but a simple set of instructions and a rough idea of where things go would be very helpful. Anyone have an idea whether instructions may exist somewhere online?
With that being said, the set appears to be very detailed and once I get it cleaned up it should be a very promising upgrade to the Florida Mako bird I’ll building.
1 9 May 2019, 20:16
Jorge AvilaI too just received my set that I have on my to do list. Let me know if you find anything.
24 May 2021, 21:23
hamptonracingI was never able to find any instructions, but a great resource to figure out where everything goes is the Jake Melampy book "The Modern Viper Guide, 2nd Ed.". It is probably the best Viper reference I've ever seen and was invaluable in helping me to use the Blackdog set. With that being said, you'll have carefully measure where to cut the kit plastic in order to get the resin to fit. There aren't any guides for that, so it just takes a lot of patience and careful measurement. Good luck!
26 May 2021, 01:59
Falk RölligIt's always challenging to find the right panel lines to cut out but the photos are a little help. Maybe you can also try to contact MP original master models, if he can give you some advice. m.facebook.com/pages..els-236571760139543/
26 May 2021, 03:24
参考资料
