F-107A Ultra SabreПереглянути: Слайд-шоу Мозаїка Список 1September 4, 2022One panel line missing. Interesting error. 2September 4, 2022Cockpit fits well. Not much details. 3September 4, 2022I have three ongoing jet projects and for a short moment they all were in same stage with the cockpit 4September 4, 2022Not sure if it shows, but there were mysterious spots on the plastic. 5September 4, 2022Some sanding 6September 4, 2022Trying to get the wing straight 7September 4, 2022Canopy on place. 8September 4, 2022The hafl sphere underside the fuselage should not be round, so I modified it. Thanks to primeportal.net/hang..bre/index.php?Page=1 9September 18, 2022Sanded the wingtip straight 10September 18, 2022Added a little PS piece as a new navigation light 11September 18, 2022Engine cowling 12September 26, 2022 13September 26, 2022I finally got the air intake done. It was difficult to sand and it was discouraging, because it is 2mm too low (according designer.home.xs4all.nl/models/f107/f107-1.htm and I also measured it). I decided to keep on "OOB" principle. 14October 8, 2022The hole in the nose needs to be reopened for the pitot tube. 15October 8, 2022Pitot tube cemented in place. Later I added thin CA glue for smoothering the edge. 16October 8, 2022Primed with aqueous Mr.Surfacer 1000. 17October 8, 2022Pre-shading going on. 18October 9, 2022It is still difficult to let the shading be visible. 19October 9, 2022 20October 9, 2022I pre-shaded red areas with yellow because I was curious. 21October 9, 2022 22October 9, 2022Bigger areas painted. Next is details. 23October 14, 2022Lots of details painted. During the weekend I hope to get decals applied. 24October 15, 2022Horrible decals are in place. 25October 15, 2022The air brakes are hold in place with blue tack. Decals are then cut with a knife along the panel edges. 26October 15, 2022 27October 16, 2022Air brake in place. 28October 21, 2022Under carriage on place. I should have dryfitted landing gear doors before painting anything... 29October 21, 2022Rudder and elevator in place. 30October 21, 2022Canopy mask removed and holy crap it is dirty and dusty inside... I should have checked it better before gluing. 31October 23, 2022 32October 23, 2022 33October 23, 2022 34October 23, 2022 35October 23, 2022 36October 23, 2022 37October 23, 2022 38October 23, 2022 39October 23, 2022 40October 23, 2022 Коментарі8 November 2024, 11:57 - Album infoFast out of the box model.F-107A Ultra Sabre OOB40 зображення1:72ЗавершеніУсі альбомиПереглянути всі альбоми »