October 6, 2021
Since there should also be a detailed seat, I had to copy again at Sparco. I designed new adjusters and buckels. This time in 2 parts, so that you can slide in the belt elements if you want. The adjusters are a little different from Sabelt and have a loop on one eyelet. I will recreate this with simple colored tape. The straps will get decals again later...
I drilled a hole in the seat, which also gets its decals (I hadn't planned one, but it turns out differently than you think - since I've only now found a few good photos). But basically that's not an issue and it's Scratch... and modeling is just modeling. The two loops that are passed through the other 4 belt elements come through the hole.