MSTA-S

1
April 8, 2020
Sprue A
2
April 8, 2020
Sprue B
3
April 8, 2020
Sprue C
4
April 8, 2020
tracks
5
April 8, 2020
decals
6
April 8, 2020
A plethora of molded on grab handles
7
April 8, 2020
so cut these away, beware of surrounding detail
8
April 8, 2020
Don't sand yet, use the white marking to place 2 center holes at the ends
9
April 8, 2020
these will keep the tip of the drill at it's place, and make sure you drill at the right spot
10
April 8, 2020
drilled out slightly larger then the wire you want to insert
11
April 8, 2020
now you can sand/scrape flush
12
April 8, 2020
For 1/72 I usually use 0.3mm wire, give it a sharp bend for starters
13
April 8, 2020
fit it through the opening
14
April 8, 2020
I know there are handle tools, but distance isn't always perfect... So I measure it like this: I put the tip of the pliers at the end (furthest point) of the drilled opening, Then keep the pliers in this position while removing the handle
15
April 8, 2020
bit clearer 😉
16
April 8, 2020
then bend, results in a perfect fit
17
April 8, 2020
nice, the put the wire totally down
18
April 8, 2020
apply some CA
19
April 8, 2020
and move the wire a bit outward. You get some glue in the opening like this. For equal distances, you can also add a small plate under the handles to use as a spacer.
20
April 8, 2020
General view
21
April 8, 2020
General view
22
April 8, 2020
General view
23
April 8, 2020
General view
24
April 9, 2020
Ccupolla ready, except from some details to be added after painting
25
April 9, 2020
overview
26
May 2, 2020
The choosen camo.. at least an attempt to replicate this
27
May 2, 2020
First layer with buff... this pics replicates the color the best
28
May 2, 2020
29
May 2, 2020
Turret too
30
May 2, 2020
31
May 2, 2020
and details...
32
May 5, 2020
After 2 evenings of taping...
33
May 8, 2020
and a lot of tape later....
34
May 8, 2020
and lots of tape and time later....
35
May 8, 2020
and lots of tape and time later....
36
May 8, 2020
and lots of tape and time later....
37
May 8, 2020
and lots of tape and time later....
38
May 8, 2020
39
May 8, 2020
Mix given wasn't right... aaarghhh
40
May 8, 2020
unpacking time....
41
May 8, 2020
unpacking time....
42
May 8, 2020
unpacking time....
43
May 8, 2020
unpacking time....
44
May 12, 2020
Taped in again...
45
May 12, 2020
Taped in again...
46
May 12, 2020
Taped in again...
47
May 12, 2020
Taped in again...
48
May 12, 2020
and last color on
49
May 12, 2020
and last color on
50
May 12, 2020
and last color on
51
May 12, 2020
and last color on
52
May 21, 2020
wheels and tracks mounted
53
May 21, 2020
wheels and tracks mounted

Bart Goesaert
Thank you. I've checked the site here for the instruction manuals of the several T-90, MSTA, Coalitsia in this camouflage (Trumpeter, Meng, ...) but found the ocre (middle tone) too much off, so ended up mixing a blend till it looked a bit like the pictures (yellow, brown, buff, but the final mix... that was on the go, so the ratio's... I don't know

26 July 2022, 17:04