The only interior parts are the seats and console. The hull was thinned and a rear bulkhead and floor was added from styrene sheet. The seats were such rough castings they needed filler!
New louvres installed and rear part of canopy installed (this later broke off due to handling). Extra thick panel lines filled and panel lines rescribed
Rotors reshaped, main rotor hub parts made from brass tube and wire, styrene tube and sheet. Still a lot of detail to add
Комментарии
25 December 2024, 05:16 -
Album info
My version of the Flying Checkpoint Hiller UH-4 seen in Destination Moon. The Unicraft kit is a very rough resin kit with no detail parts - you need to build your own rotor hub , main undercarriage and any details.
