Tunguska, W-model 1/72

1
April 5, 2019
Basic hull as per kit, doesn't fit the upper hull
2
April 5, 2019
almost a mm has to disappear from both sides
3
April 5, 2019
rear plate doesn't fit too
4
April 5, 2019
Preparation of the necessary cuts
5
April 5, 2019
dryfit
6
April 5, 2019
the furthest sidewall is too long
7
April 5, 2019
removed the inside material
8
April 5, 2019
dryfit of the rear plate. aligned it to preserve the details. There's still a 4mm gap
9
April 5, 2019
Rear plate cut in half
10
April 5, 2019
upper part glued in place
11
April 5, 2019
first glued the outer parts in place, then centered the mid part
12
April 5, 2019
some necessary filling was needed...
13
April 5, 2019
this sidewall protrudes about 0.5mm... more filling and sanding...
14
April 11, 2019
Rocket launcher tubes are a bit... euh... distorted... Awaiting some 2.4/2.5mm round styrene to scratch these
15
April 11, 2019
rear is round
16
April 11, 2019
cut off the ends, overall shape on this side is oval...

Comentários

5 April 2019, 07:46

Bart Goesaert
Started this new one from W-model. To be honest... a bit of a let down, a lot of rework is needed. Had contact about it with the manufacturer, and they will upgrade the molds. They also offered new parts, but I wanted to try to solve it, and have the new parts as a back-up plan...

5 April 2019, 08:00

Zsolt Czegle
I'm following!

You have done a lot of reworks still at the beginning of the build! It will be a really sweating work! I hope at the end it will be a fun!

5 April 2019, 14:31