AH-1W
took a false start
resin from the engine set and the resin nose that came with the decals
allready cleaned parts
dryfit of the main resin parts
dryfit of the main resin parts
dryfit of the main resin parts
dryfit of the main resin parts
Start of the nosejob, easy part, remove the original part
then dry-fit the replacement, so far so good
but when checking with the glass parts it becomes another story... the angle is completely off. Need to think hoh to cope with this...
al lot of CA to fill the seams. Hope it will work well, because the plastic is terribly soft
al lot of CA to fill the seams. Hope it will work well, because the plastic is terribly soft
and scraped and sanded for the first time (I've removed some details with a knife to avoid damaging them, they will be reglued afterwards), ready to check the result with paint... Fingers crossed
and sanded for the first time, ready to check the result with paint... Fingers crossed
Bottom hull needed a lot of TLC too
Comments
5 October 2024, 06:07 -