gundam modeling database | samlingsverktøy
WhiteGlint
Robin (WhiteGlint) (WhiteGlint)
DE

Yoshi 3D print

Kommentarer

8 16 December 2021, 20:02
Robin (WhiteGlint)
3D printed Yoshi to gain some more experience with resin figures.
Especially with cleaning and (brush) painting.

Here my job cleaning was not the best one and I need to be more diligent in the future.
I had less problems with my Catapult.
As I don't want to work with lots of isopropyl alcohol I cleaned Yoshi in warm water with dish detergent.

Some varnish will hopefully solve my problems as this little guy still is a bit sticky, even after the paint has dried.
 16 December 2021, 20:24
S M
Do you have a cure machine or uv-light for curing the resodue resin?
 16 December 2021, 20:39
Robin (WhiteGlint)
Yes, I use the Anycubic wash and Cure Station 2.0.
But even these tools need to be used right. 🤔
I think maybe I didn't clean good enough and did not cure long enough. Though curing too long should make the parts very brittle, I believe.
 16 December 2021, 20:49
S M
Ok that's strange. Although I'm not an expert and I don't own any 3D printer. I have been dreaming of resin printer but my apartment is too small and I'm afraid of fumes. Maybe Santa will give me a garage some day...
 17 December 2021, 16:59
Robin (WhiteGlint)
As I use the printer inside my house as well and I am not a fan of toxic fumes either, I use only plant-based resins which are not toxic.
But it still smells bad, especially when removing the cover from the printer after the print has finished. 😄
Using some protection like gloves and a mask is still very much recommended.

Working with plant-based resin may be an option for you.
The printer I am using is quite small too, so the parts I can print are not that large either. If you want I can provide you some pictures and measurements.
 17 December 2021, 18:16
S M
Thanks! You can PM them to me. btw what is the source of that Yoshi's 3D-model?
 17 December 2021, 22:56
Robin (WhiteGlint)
Yoshi's from Thingiverse.
thingiverse.com/thing:4788638

I'll write you a PM regarding the printer and so on.
 18 December 2021, 09:15
Robin (WhiteGlint)
Finished. Fun little project. 🙂
 19 December 2021, 14:23
S M
Nice base👍
 19 December 2021, 18:32
Robin (WhiteGlint)
Thank you. 🙂
 20 December 2021, 10:09
Guy Rump
Very nice 👍
 21 December 2021, 23:23
Robin (WhiteGlint)
Thanks guys! 🙂
 23 December 2021, 14:16
Simon Nagorsnik
Funny idea!!
Like it very much and nice presentation👍
 23 December 2021, 14:25

Album info

Cute little Yoshi from Nintendo to gain some experience with figure painting and to have an excuse to print some more stuff.

9 bilder
No
Fullført
Scratchbuilt

Alle album

Se alle albumer »