PLA Type 22

Main parts 

Main hull parts 

Main hull and bridge 

Railings and miscelaneous 

Missiles and clear parts 

PE 

decals 

should be filled 

so some sprue to fill most, then putty, to avoid melting the plastic by the dissolvants 

after sanding 

basic mast 

removed steps, and drilled holes 

brass wire 0.3mm 

steps in their places, by pressing them to the surface they set themselves to the width of the hole 

the I pull them randomly forward 

Here i place some spacers (2 drills of 0.5mm in this case), to get an equal distance for each step 

I glue them mostly on the inside with thin CA, but here it is hard to reach, so I glued them on the outside too. Some CA residue is visible 

inside view, pretty cosy 

3mm glassfibre pen to the rescue, along with some slight scraping with a scalpel first 

cleaned up 

thinning the walls 

radar-unit seemed thick 

thinned the walls by scraping them round 

added the guiding lines for attempt to add canning 

added the guiding lines for attempt to add canning 

Example of canning, don't know the exact word 

Example of canning, don't know the exact word 

first blood, euuhm dust...