Trade Federation Advanced Bomber

1
April 25, 2024
The original file was a single piece - I cut it into 2 halves to fit on my printer. Th eyes were open for lighting but I filled them with clear resin, tinted red, sanded and polished
2
April 25, 2024
The original file also had a mounting hole, for which I made a plug with Aves epoxy putty
3
April 25, 2024
The inside of the engine grills was covered in a clear plastic sheet, which was later painted on the inside with clear blue followed by silver
4
April 25, 2024
The two halves were glued together
5
April 25, 2024
The whole ship, with some filling around the seam and further polishing of the eyes
6
April 25, 2024
Masking completed on the eyes
7
April 25, 2024
After a couple of coats of primer with some further sanding and filling in between
8
April 27, 2024
Main painting complete - bottom vi
9
April 27, 2024
Main painting complete - top view. Just some detail painting to do
10
May 21, 2024
11
May 21, 2024
12
May 21, 2024
13
May 21, 2024
14
May 21, 2024
15
May 21, 2024
16
May 21, 2024
17
May 21, 2024

Kommentarer

4 25 April, 13:24

Uwe Kaeding
Finished - a nice quick project

21 May, 12:43

Album info

This is a 3D printed model of the Trade Federation Advanced Droid Bomber, as seen in the Star Wares: Episode 1: Battle for Naboo video game. The model is printed from a file from Zarkus Model Kits and available on Thingiverse. The original files are scaled at 1/144 but I upscaled them to 1/72 - I only scaled them up by 172.5% however as at 200% it just looked too big compared to other 1/72 models.

Star Wars: Separatist Fighters and Bombers

35 bilder

1:72

Påbegynt

1:144 Trade Federation Light Bomber (Zarkus )

1:144 Trade Federation Advanced Bomber (Zarkus )

Alle album

Se alle albumer »