Fujimi F-16C 1/72
1February 7, 2025
2February 7, 2025
3February 7, 2025Had to add the front bulkhead to the main landing gear bay.
ALQ-131 ECM is from the HAS Weapons IV
4February 8, 2025Intake gaps on both sides
5February 7, 2025quickboost seat is a good upgrade over the very basic kit seat.
6February 7, 2025kit fuel tank pylon kitbashed onto a Ita fuel tank
7February 7, 2025Hole in aft part of cockpit, also no signs of a HUD
What gives Fujimi?
8February 7, 2025Bulkhead added to aft part of cockpit(to plug the hole)
9February 7, 2025Hasegawa Wing tip launchers(LAU-129) installed.
10February 8, 2025Took the exhaust from the Italeri f-16 #188 which is a basic updated version(GE type) from the kit supplied exhaust(P&W)
11February 10, 2025Kitbashed HUD installed I think it's off an AMT F-16 kit(paint mule)
12February 10, 2025Master Pitot and AOA's installed.
Sadly the carpet monster ate the center pull handle for the seat.
made one out of wire... I need to get some thinner brass wire 🙁
13February 10, 2025STYNYLREZ black primer
14February 10, 2025Base color MRP-039 FS36270 went down well
15February 10, 2025Top coat of MRP-040 FS36118
16February 10, 2025tape removed no runs
17February 10, 2025First round with the kit decals, they didn't not want to come of the paper(yes I did use warm distilled water). But no cracks and thinner than HAS decals.
18February 10, 2025shark mouth fought me
I used AK paint pens for the JFS door and A/A refueling point.
19February 10, 2025might have reapply more Tamiya decal juice... some of the "US" stars and bars are a little cloudy.
20February 10, 2025AGM-88E from the Tamiya F-16 looked good until I sprayed the final color, I didn't see the seam line in primer!
コメント
6 7 February, 21:38
Album info
This was a build I was talked into by new Co_works. Sadly, I found out the that Fujimi F-16 is hands down the worst 1/72 F-16 I will ever build.
