Ford 427 SOHC Engine
- Scala:
- 1:6
- Stato:
- Completato
- Iniziato:
- March 8, 2020
- Completato:
- March 9, 2020
- Tempo impiegato:
- 4hrs
Started this just for other's reference in the future. There's a few watch-outs on this to make sure it assembles right.
3 of 4 oil pan bosses broke when running the screws in. had to CA.
Throttle linkage arm would not fit the way the instructions show it. had to reverse it which leaves a ejection pin mark visible, to get it to connect the arm to the linkage.
Instructions don't show assembling the water neck to the flange...you do need to do this for it to look right but you can miss it because the neck will go on without the flange.
Inventario del progetto
Kit completi
/it/search.php?q=*&fkMATEID[]=17812&showast=no&fkWORKBENCH[]=WB17812&page=projects&project=70413?
Foto albums
Commenti
9 March 2020, 15:51