MSN-04 Sazabi (Bandai RG 29)
A) Be sure you insert the funnel peg with the open (pinhole) end facing out. Once you get it in there it's not easy to remove without damaging that peg.
B) I recommend inserting the launch 'blast' base plug into the blast effect before attempting to insert the thruster trail...
The launch/base blast effect's outer fringes are soft and it can be easy to bend those fine ends inward while trying to insert the end of the long thruster trails into it. Try to line it up and use a slight twisting motion (rolling the thruster trail back & forth) while gently inserting to avoid snagging those blast fringes.
I tried replacing some of the launch base pins with the spares in the pack. 1 actually helped.
For the other 3 I had to gently squeeze them with needlenose pliers where they attach to the launcher. Only do this once to narrow the channel. don't try to make the whole thing smaller by repeating it.
Honestly, if I didn't want the option to repose and remove the effects, gluing them would have saved me a headache. ?
Commenti
Tom HarrisThanks, Dash! I also get to a point where I wonder, "Should I stop here?"😅 But that Leynos diorama you did is wonderful! 🤘🙂
Dash RendarThank you thank you. Yeah, the thing is weathering is to find the right amount (and scale). It can be very tricky.
Album info
First serious build in... decades!
Interest re-sparked when, on a lark, my wife & I picked up 2 HGUC kits at our local Target (RX-78-02 & Char's Zaku II), simply because she had never built a model and decided she wanted to. 🙂
After that I began stalking this kit from Char's Counterattack, because I liked the design. I finally found it in stock and for a reasonable price in the fall of 2021. Begun September 23rd as an off-and-off project and applied top-coat on May 3rd.
Not only a reintroduction and renewed joy in assembly, it was also a reeducation! Nippers were new to me (I was taught to use X-acto knives by my father over 4 decades ago! LOL) and paints were always applied from a small glass jar (or dad's airbrush).
Touches of paints were applied for details and weathering effects via Gundam Markers (GM20, GM152 from the Metallic Set, GM401; GM402, GM404 from the Real Touch Set 1; Tamiya Panel Line Accent Color Dark Gray ) either directly, by brush from pools extracted from the marker. GM400 (also from the Real Touch set), cotton swabs and small torn sponge pieces were used for blending.
Anyway, I'm pretty pleased with the results (and very glad I opted for water-slide decals instead of these packaged stickers for the armor's markings (I had applied a few of the silver ones to the frame during the early stages of the build). Pardon the multitude of photos. I've been trying to capture the details as well as the spirit of the kit and feel like my camera isn't presenting everything that I see. 😛
