Red Alert 2 - Tesla Tank
1
November 4, 2021First steps with 3D printing, lot of tests and failures incoming.2
November 4, 2021Reference for what I am aiming for. The hull from the T-90 won't probably changed much, though I will try to recreate the rear part above the engine deck and the turret as good as possible.3
November 7, 2021First samples printed. A little bit too small, I think.4
November 27, 2021Working with resin is different.5
November 27, 2021First coil6
November 27, 2021Possible setup7
November 28, 20218
November 28, 20219
November 28, 202110
November 28, 202111
December 6, 2021Pre-shading done.12
December 6, 2021Pre-shading done.13
December 7, 202114
December 7, 202115
December 7, 202116
December 7, 202117
December 7, 202118
December 7, 202119
December 7, 202120
December 7, 202121
December 7, 202122
December 7, 202123
December 7, 202124
December 7, 202125
December 7, 202126
January 9, 2022Finished Tesla Tank27
January 9, 2022Finished Tesla Tank28
January 9, 2022Finished Tesla Tank29
January 9, 2022It should read "lightning rod". I hope it is correct.30
January 9, 202231
January 9, 202232
January 9, 202233
January 9, 202234
January 9, 202235
January 9, 202236
January 9, 202237
January 9, 202238
January 9, 202239
January 9, 202240
January 9, 202241
January 9, 202242
January 9, 2022
Commenti
8 September 2024, 04:55 -