A-20G Hacoc 1/72 "La France Libre" Voir: Diaporama Mosaïque Liste 1 April 9, 2022
The original plastic cockpit is so simplified that I strongly recommend checking the PE set in the box or you may buy it on aftermarket.
2 April 9, 2022
The worst fitting in this kit. I have to cut out the floor about 2mm, on both sides...Then clear out the excessing details on the walls.
3 April 9, 2022
After that, the upper seam is acceptable for fitting the nose part.
4 5 6 April 9, 2022
Dry-fit is a must.
7 April 9, 2022
Dry-fit is a must.
8 April 10, 2022
At first, I thought the gear/engine bay can be glued before the gears so. It's NOT.
9 10 11 April 14, 2022
Engines are well cast, so they deserve adding more details. 🙂
12 13 April 16, 2022
Some of these invasion stripes will be covered by OD.
14 15 April 20, 2022
Enlightened. I think there was a little bit too dark on the upper side.
16 April 22, 2022
Decals were good！
17 April 22, 2022
Gray line is much more better, yet I believe that I should do more enlightening on panels
18 April 23, 2022
Enlightened, again.
19 20 April 23, 2022
Almost there
21 April 23, 2022
Almost there
22 April 24, 2022
Propellers' on.
23 24 April 24, 2022
Copper wire is not good enough, I have brought elastic wire for 1/700 ships, just wait.
25 26 27 28 29 30 May 5, 2022
Note here: The intake above the engines have to scoop out，otherwise they were solid plastic.
31 Commentaires 26 November 2024, 04:50 -
Album info Hi everyone! When I was waiting materials for my carrier elevator. I decided to open a MPM kit of A-20G. To be honest, the fitting of this kit is quite disappointing, yet a piece of Eduard's coloured PE is a plus.
31 images
1:72
Terminé
Douglas A-20G-25 Havoc US Army Air Forces (1941-1947) 668 BS, 416 BG, 9 AF 5H-E | 43-9224 La France Libre Août 1944 World War 2 - A-55, Melun
FS33070 FS34092 FS36173 FS37875 FS37038
Tous les albums Voir tous les albums » 
