Red Alert 2 - Tesla Tank

First steps with 3D printing, lot of tests and failures incoming. 

Reference for what I am aiming for. The hull from the T-90 won't probably changed much, though I will try to recreate the rear part above the engine deck and the turret as good as possible. 

First samples printed. A little bit too small, I think. 

Working with resin is different. 

First coil 

Possible setup 

 

 

 

 

Pre-shading done. 

Pre-shading done. 

 

 

 

 

 

 

 

 

 

 

 

 

 

Finished Tesla Tank 

Finished Tesla Tank 

Finished Tesla Tank 

It should read "lightning rod". I hope it is correct.