SA-8 Gecko/9k33 OSA

1
November 22, 2017
Main hull, construction was pretty straightforward
2
November 22, 2017
Some interior is provided... not that much wil be seen without major surgery
3
November 22, 2017
4
November 22, 2017
rooftop and turret base with basic parts added
5
November 22, 2017
other side
6
November 22, 2017
some dryfit
7
November 22, 2017
rocket cannisters, still a bit warped
8
November 22, 2017
base for the cannisters
9
November 22, 2017
Lower radar unit
10
November 22, 2017
Middle radar unit, a bit in doubt wether to replace all strengtening bars with rod....
11
November 23, 2017
camo choices 1
12
November 23, 2017
camo choices 2
13
November 23, 2017
camo choices 3
14
November 23, 2017
camo choices 4
15
November 23, 2017
camo choices 5
16
November 23, 2017
camo choices 6
17
November 23, 2017
camo choices 7
18
November 23, 2017
camo choices 8
19
November 23, 2017
camo choices 9
20
November 23, 2017
camo choices 10
21
October 5, 2018
Wheels fitted
22
October 5, 2018
Wheels fitted
23
October 5, 2018
Thinned the resin struts for the launcher supports... 1 down, 1 to go. Maybe I'll try to get a bit thinner...
24
October 5, 2018
problem with windshield, positioned in the middle, just thicken it to both sides?
25
October 5, 2018
here it is, positioned to one side...
26
October 6, 2018
tried the saw first, need to redo the right top side, but it is perfect in width, now restoring the detail, or at least try to
27
October 8, 2018
cleaned up, ready for primer to test the result
28
October 8, 2018
dryfit, looks a lot better
29
October 9, 2018
tested with black paint to check the seams, looks ok after a few iterations

Kommentit

2 22 November 2017, 07:14

Bart Goesaert
basic construction soon finished...

22 November 2017, 07:43

Zsolt Czegle
Following with interest!!

22 November 2017, 08:01

Bart Goesaert
thx. hope not to disappoint. already looking out for some camouflage on this one, and maybe a small change to make it an AMK instead of a standard one...

23 November 2017, 11:21

Alec K
What a beast! Nice progress 👍

24 November 2017, 14:54

Bart Goesaert
Progress was a bit slower then expected... Wheels fitted under the hull, only 1 needs a bit of correction for not touching the ground (to me it's a succes...)
Also thinned down one support for the launchers... some tedious work, but luckily the resin isn't that brittle. Further I ran into a serious problem with the windshield part. It is approx. 1.5mm smaller then the hull, and I'm very puzzled how to deal with that

5 October 2018, 11:25