WIP - VW T1
Kommentare
9 9 July 2020, 18:50
Thomas Steinke@Spanjaard: Printer is a Elegoo Mars SLA printer.
@Dominik Weitzer: Thanks! 👍
21 May 2021, 10:26
Thomas SteinkeDon't hesitate to contact me if I can help you in this direction in any way.
21 May 2021, 11:29
Spanjaarddo you need any other machine or just the printer. because i see also some UV cure ones of the same brand, for example
21 May 2021, 11:33
Thomas SteinkeYes I love my printer 😄 I've been able to make so many improvements with it.
21 May 2021, 11:33
Thomas SteinkeYou need a uv lamp of 405nm. A curing machine is not absolutely necessary.
23 May 2021, 15:04
Rui SGreat stuf, I'm hopping that with so many, house made stuf ,the prices may go down a bit?
May I ask, how much did those pieces cost you?
23 May 2021, 16:37
Spanjaardin the pictures is possible lto see some lines. but those are certainly zoomed. how do they look to the naked eye and to the touch? smooth or not?
15 January 2022, 23:15
Ben MHi spanjaard, resin printers leave a slight texture, not as much as fdm printers. You don't even really need a 405nm UV lamp. I use the sun to harden my prints.
15 January 2022, 23:20
Thomas SteinkeThe print isn't necessarily the best in the pictures, and the print orientation certainly wasn't the best choice either. I have to say it was the first steps with the printer back then. The layer height could also be improved. Now I have to say I get the parts without wanting to praise myself in such a way that you can only see them under a large magnifying glass and you can basically no longer feel them with your finger. Hope this helps.... 🙂
16 January 2022, 00:02
SpanjaardThanks Ben and Thomas. About the UV lamp to cure, iam curious. Ben does not use it, I see. No problems at all? I think I have read something about the prints getting brittle if too much curing
16 January 2022, 21:14
Thomas SteinkeThey have a pre-curing when printing and you need a post curing after printing. Sun light is also possible, but it needs a longer time for this curing process.
16 January 2022, 21:29
Ben MI haven't had problems with brittleness. I normally leave them out in the sun 2-4 hours, turning them occasionally.
16 January 2022, 21:50
Spanjaardyeah, i may have similar issue in Amsterdam 😛 . what about washing after printing. i see that some brands also have curing/washing devices.
17 January 2022, 09:21
Thomas SteinkeI have a combined device, but I also wash a lot by hand with a brush, because sometimes the result is more precise and more cleaner with small parts and narrow grooves.
@Michael: Project is on hold at the moment.
17 January 2022, 14:03
Ben MTo clean parts, I use a paint bucket full of isopropyl alcohol and then after parts soak for a few minutes immersed in that, I move them into my laundry sink where I rinse them off, have a couple brushes, etc.
If it's cloudy, there's still UV light, just have to leave things out a little longer. It's not always sunny in Colorado either.
17 January 2022, 16:45
Richard ChealsGreat discussion, mates. My future 3D printer project is gradually gathering momentum heh heh.
17 January 2022, 17:03
