Eduard Fokker Dr.I stripdown Anzeigen: Diashow Mosaik Liste 1June 2, 2014engine resin base 2June 2, 2014engine, freeing the tubes 3June 2, 2014engine, freeing the tubes 4June 2, 2014busy soldering 5June 2, 2014PE-base for mg's 6June 2, 2014one MG finished 7June 2, 2014soldering the engine mount 8August 26, 2014basepart upper wing 9August 26, 2014folded and ready for soldering 10August 26, 2014soldered wing, still need to clean-up 11August 26, 2014soldered wing, still need to clean-up 12August 26, 2014soldered wing, still need to clean-up 13August 28, 2014baseparts 14August 28, 2014base midwing 15August 28, 2014base midwing 16August 28, 2014testfit 17August 28, 2014With frontparts in place 18August 28, 2014With frontparts in place 19January 27, 2015bottomplate treated with woodpaint from vallejo and oil-paint for veneer look, a tad too dark in my opinion 20January 27, 2015sideplates treated with decals from uschi, paint on the sides needs to be cleaned 21January 27, 2015centre spar with same treatment as with the bottomplate, but instead with pushing the brush up and down, you streak the brush lenghtwise 22January 27, 2015wheels need to be repainted/cleaned up 23January 29, 2015different stages of painting the wings 24January 29, 2015some detail 25January 29, 2015better picture of the engine 26January 29, 2015The hull, almost complete 27January 29, 2015and it's mega-size, still regretting the airco dh-1 1:144 as stripdown-model 28January 29, 2015struts Kommentare25 November 2024, 13:28 - Project infoFokker Dr.I Stripdown28 Bilder1:72IdeenAlle AlbenAlle Alben anzeigen »