Otaki 1/12 trans am
Kommentare
10 28 August, 15:05
Rod -
This kit is more than 50 years old and amazingly good. The original tires in my kit had decomposed to mush so I got some Tamiya RC tires, machined some rims and 3d printed some centres.
The kit comes with a motor, lights and wiring. Motor hidden in engine block, 4x AA in the fuel tank. It even has little uni joints on the tail shaft.
This kit is more than 50 years old and amazingly good. The original tires in my kit had decomposed to mush so I got some Tamiya RC tires, machined some rims and 3d printed some centres.
The kit comes with a motor, lights and wiring. Motor hidden in engine block, 4x AA in the fuel tank. It even has little uni joints on the tail shaft.
28 August, 15:12
Rod -
I've spent a bit of time trying to get the stance right. Out of box it sits quite high.
I've spent a bit of time trying to get the stance right. Out of box it sits quite high.
28 August, 15:13
Rod -
I have a cnc lathe at home. It has a 75mm spindle bore, a bit bigger than a hobby lathe 🙂
I have a cnc lathe at home. It has a 75mm spindle bore, a bit bigger than a hobby lathe 🙂
28 August, 23:01
Rod -
Dash gauge decals pinched from a 1/12 foose camaro kit. The original decal sheet only gives you 3 choices of screaming chicken and a big blue stripe. No badges or detailing of any kind. The silver trim is a separate piece. I glued some green felt on the floor for carpet.
Dash gauge decals pinched from a 1/12 foose camaro kit. The original decal sheet only gives you 3 choices of screaming chicken and a big blue stripe. No badges or detailing of any kind. The silver trim is a separate piece. I glued some green felt on the floor for carpet.
22 September, 12:05
Rod -
I'm waiting on some 3d printed brake rotors and calipers. There will be more pics soon 🙂
I'm waiting on some 3d printed brake rotors and calipers. There will be more pics soon 🙂
22 September, 14:38